Adc Dac Baremetal

ADC and DAC (Bare-Metal)

Purpose

Configure ADC and DAC peripherals: channel selection, sampling times, calibration sequences, DMA circular buffers, and DAC static/dynamic output.

When to Use

• Reading analog sensors (temperature, voltage)
• Audio or control voltage output via DAC
• Continuous sampling with DMA
• Post-reset ADC calibration on STM32

Workflow

1. STM32 ADC single conversion

/* Enable ADC1 and GPIOA clock; PA0 analog mode */
ADC1->CR2 |= ADC_CR2_ADON;
for (volatile int i = 0; i < 10000; i++);  /* stabilization — RM value */

ADC1->SMPR2 |= ADC_SMPR2_SMP0_2;  /* 84 cycles sample time ch0 */
ADC1->SQR3   = 0;                 /* channel 0, 1 conversion */
ADC1->CR2   |= ADC_CR2_SWSTART;

while (!(ADC1->SR & ADC_SR_EOC))
    ;
uint16_t sample = ADC1->DR;

Run ADC_Calibration() / ADC_CR2_RSTCAL/CAL per RM on F1/F4 families.

2. DMA circular ADC

/* ADC1 → DMA2 Stream0, circular mode into buffer[64] */
/* Configure DMA: periph-to-mem, halfword, increment mem, circular */
ADC1->CR2 |= ADC_CR2_DMA | ADC_CR2_CONT;
DMA2_Stream0->CR |= DMA_SxCR_EN;

Half-transfer / transfer-complete IRQs for double buffering.

3. DAC output (STM32)

RCC->APB1ENR |= RCC_APB1ENR_DACEN;
DAC->CR |= DAC_CR_EN1;
DAC->DHR12R1 = 2048;  /* mid-scale 3.3V reference */

4. Agent usage

/adc-dac-baremetal Set up ADC1 channel 0 with DMA circular buffer

Common Problems

Related Skills

• skills/baremetal/dma-baremetal — ADC DMA streams
• skills/baremetal/timers-pwm-baremetal — ADC external trigger
• skills/baremetal/gpio-baremetal — analog pin mode